Sealprotect® Bath Cover for Forearm

Features and Benefits

The bath cover consists of a plastic ring with an inner silicone membrane, which you slide your hand through before guiding your arm into the vinyl sleeve.

It's important that the silicone seal sits above the bandage/cast and fits tightly.

The bath cover can be reused multiple times, up to a maximum duration of 2 months. Allow it to air dry between uses.

Plastic Ring Dimensions:

• Inner Circumference: 40 cm
• Outer Circumference: 49 cm
• Inner Diameter: 13 cm
• Outer Diameter: 15 cm

Vinyl Sleeve Dimensions:

• Length: 51 cm

Measure from the tip of the longest finger to the end of the area to be protected - cast, bandage, prosthesis, or similar. Add 4 cm to get the correct length for your bath protector.

Note the maximum measurement for circumference including cast, dressing, or similar.

Instructions:

1. Hold the plastic ring firmly and create a large opening with your hands, pulling SealProtect ® up as high as possible. Be careful not to apply pressure to the plastic ring when putting on SealProtect ®.

2. Ensure that SealProtect ® is positioned at least 3 cm above the cast, dressing, splint, or similar for optimal protection.

3. Gently press the plastic ring down a bit so the silicone membrane flips upwards as shown in the last image.

It is important to dry the ring and rubber membrane before removing SealProtect to avoid water collection in the ring, where the rubber membrane sits.

Safety:

• SealProtect ® can become slippery when wet.

• Use SealProtect ® with caution.

• Adult supervision is recommended when children use SealProtect ®.

• Dry SealProtect ® with a towel only.

• Do not dry SealProtect ® on a heater.